Как заменить задние тормозные колодки на ниссан кашкай j11
If you own a Nissan Qashqai J11 and need to replace the rear brake pads, here is a guide to help you through the process. Replacing the rear brake pads is not as difficult as you may think and can save you money over having a mechanic do it for you. Follow these simple steps and you will easily have your Nissan Qashqai J11 brakes back in good working order.
Step 1: Gather the Necessary Tools
Before you start the process of replacing the rear brake pads on your Nissan Qashqai J11, you need to make sure you have all the necessary tools. You will need a jack stand, wrench, a pair of pliers, a C-clamp or a piston compression tool, a torque wrench, and a brake cleaner. Make sure you have all the necessary tools handy before you begin.
Step 2: Jack Up Your Car & Remove the Rear Tire
Before you start, make sure your car is turned off and parked in a safe area. Jack up your car and secure it on a jack stand. Remove the rear tire and locate the brake pads.
Step 3: Remove the Brake Pad Clip or Retainer
You need to remove the brake pad clip or retainer by using a pair of pliers. This allows you to remove the brake pads from the caliper.
Step 4: Remove the Old Brake Pads
You will now remove the old brake pads. You can do this by pushing them out of the caliper using a flat screwdriver or pliers. If the brake pads are hard to remove, you may need to use a C-clamp or compression tool to compress the brake piston.
Step 5: Clean the Brake Calipers
To ensure the new brake pads fit correctly, clean the brake calipers with a brake cleaner. Spray the cleaner on liberally and remove any dirt, debris, or grime from the caliper.
Step 6: Install New Brake Pads
Install the new brake pads in the caliper and make sure they are seated correctly. You may need to use a C-clamp or compression tool to compress the brake piston when installing the new brake pads.
Step 7; Reinstall the Brake Pad Clips
Once the new brake pads are installed, reattach the brake pad clip or retainer to hold the pads in place.
Step 8; Repeat Steps 3-7 for the Other Wheel
Repeat steps 3 through 7 for the other rear wheel. Make sure to install the new brake pads on both sides.
Step 9: Reinstall the Tires
Put the rear tires back on your car and tighten the lug nuts. You can now lower your car off the jack stand.
Step 10: Brake Pad Break-in Period
After you have replaced your Nissan Qashqai J11 brake pads, you will need to have a short break-in period. Don’t attempt heavy or hard braking during this period. Instead, drive slowly and periodically apply the brakes. This process lets the new brake pads settle in and adjust.
Replacing the rear brake pads on your Nissan Qashqai J11 is a straightforward process that requires a little bit of elbow grease and patience. However, it isn’t complicated, and it will save you a lot of money over taking it to a mechanic. As always, follow the above steps carefully to ensure your safety and the functioning of your vehicle.